HOWTO Clone Disk Images on Linux Booted from a Network
Prev		Next

3. Setting up DHCP and TFTP servers

A DHCP server is required to provide IP addresses for the clients when booting Grub (BOOTP) and later when booting Linux. A TFTP server is required to make the boot images available on the network for Linux to boot. The TFTP server is also necessary to make it possible to save and restore the disk images.

3.1. Setting up DHCP

Details on DHCP are beyond the scope of this article. The "Linux Networking HOWTO" has a chapter on DHCP.

Setting up DHCP is very easy, but if you are in a network environment administered by someone else, it's advisable to use a preexisting DHCP server. If you "own" the network then you can follow this procedure.

Install DHCP, if not installed, from the rpm package, normally found in Linux distributions:

# rpm -ihv dhcp-*.rpm

Edit the /etc/dhcpd.conf file to configure DHCP service. In our setup, the server has IP address 10.0.0.1 and provides IP addresses up to 253 clients. Configure /etc/dhcpd.conf according to your environment:

#/etc/dhcpd.conf
server-identifier dhcp.clonedomain.com;
default-lease-time      172800;
max-lease-time          604800;
option domain-name      "clonedomain.com";
subnet 10.0.0.0 netmask 255.255.255.0 {
        range dynamic-bootp 10.0.0.2 10.0.0.254;
}

Start the dhcpd server:

/etc/rc.d/init.d/dhcpd start.

3.2. Setting up TFTP

Setting up TFTP is almost as easy as DHCP.

First install from the rpm package:

# rpm -ihv tftp-server-*.rpm

Create a directory for the files:

# mkdir /tftpboot
# chown nobody:nobody /tftpboot

The directory /tftpboot is owned by user nobody, because this is the default user id set up by tftpd to access the files.

Edit the file /etc/xinetd.d/tftp to look like the following:

service tftp
{
        socket_type     = dgram
        protocol        = udp
        wait            = yes
        user            = root
        server          = /usr/sbin/in.tftpd
        server_args     = -c -s /tftpboot
        disable         = no
        per_source      = 11
        cps             = 100 2
}

The changes from the default file are the parameter disable = no (to enable the service) and the server argument -c. This argument allows for the creation of files, which is necessary if you want to save boot or disk images. You may want to make TFTP read only in normal operation.

Then reload xinetd:

/etc/rc.d/init.d/xinetd reload

You can use the tftp command, available from the tftp (client) rpm package, to test the server. At the tftp prompt, you can issue the commands put and get.

3.3. Using different servers

It is possible to use different servers for DHCP and TFTP. This may be necessary if using a preexisting DHCP server. You can configure the next-server parameter in DHCP to point to the TFTP server or you can use the command tftpserver in Grub.

Prev	Home	Next
Introduction		Preparing boot files